ª¬½¯ˆš¶ÿïÿïÿ6þÿÿøw¿ˆ8Pack*?À8 @EACTEACT1üÔfPh|€øü$”œ‚@( à¨ôø======ECON0303=======]æ¦Channel Setup øe¦Ch The Channel Setup screen shows the sensors that are currently assigned to each channel (CH1, CH2, CH3, SONIC, Mic). ¦Theæ¤To configure Channel Setup settings @E-CON2[EXE]\«Íï‰P8Pack*?À( @GUIDEøKEYLOG(ÌÔNOTEôÔ$22%22222222222222222222222$--2222%2'---$ÌzNote ø æªOn the menu that appears after you select å—Motionå˜ from either the CASIO or Vernier sensor menu, select either å—meterså˜ or å—feetå˜ as the sampling unit. € æªAfter selecting å—Motionå˜ from either the CASIO or Vernier sensor menu, you can press the [OPTN]key to toggle å—smoothing (correction of erroneous samples)å˜ on (å—‡Smoothå˜ displayed) and off (å—‡Smoothå˜ not displayed). æªMic Channel :For this channel, the sensor is automatically set to Built-in (External) Microphone. æ æªWhen you select a channel on the Channel Setup screen, the sampling range of the selected channel appears in the bottom line of the screen. æªWhenever the current Sample Setup and Trigger Setup settings become incompatible due to a change in Channel Setup settings, these settings revert automatically to their initial defaults. ø Selecting the Mic channel with Channel Setup while the Sample Setup has å—Extendedå˜ selected for the sampling mode, for example, will cause the sampling mode to change automatically to å—Fastå˜ (which is the initial default setting when the Mic channel is selected). (w